Home > Knowledge > Content
Connection mode of stainless steel pipe
- Nov 04, 2017 -

The stainless steel pipe connection Way is various, the common pipe type has the compression type, presses the tense type, the movable connection type, the propulsion type, pushes the thread type, the socket welding type, the movable flange connection, the welding type and the welding and the traditional connection unifies the derivation series connection way. These connection methods, according to its principle is different, its scope of application is also different, but most of them are easy to install, firm and reliable. Connecting the use of sealing ring or gasket material, most of the selection of national standards to meet the requirements of silicone rubber, acrylonitrile-butadiene rubber and EPDM, etc., to remove the user's worries.

Card Press Connection steps
1. Break the tube: according to the required length of cutting pipe, broken pipe, not to force too large, to prevent the Tube lost round.
2. Remove Burr: After the tube is cut off, burr should be removed clean, so as not to cut the seal ring.
3. Marking: In order to fully insert the pipe pipe socket, the insertion length must be marked on the tube end line.
4. Assembly: the sealing ring should be properly installed in the U-shaped groove of the pipe, insert the pipe into the pipe socket, waiting for crimping.
5. Crimping: Crimping, the part of the pipe raised in the mold groove, the jaw and the tube axis to maintain vertical.
6. Check: After the completion of crimping, the use of special gauges to check the size of the crimping.